Temporary works coordinator - SSP
The purpose of this standard is to provide the delegate with the knowledge to support the following scope.
You are here:
Search results
Found 752 short duration training standards. The standards are sorted in alphabetical order
Use the Download as CSV button to save these search results to your computer. We update these standards frequently, so you should check the website and download a new version regularly.
Temporary works co-ordinator piling
The purpose of this standard is to train supervisors and engineers in the piling industry on specific Temporary Works requirements.
Temporary works general awareness
This training standard is also known as: Temporary Works General Awareness Training Course (TWGATC).
Temporary works supervisor
This training standard is also known as: Temporary Works Supervisor Training Course (TWSTC).
The avoidance of buried utilities for construction utilising ground penetrating radar - GPR Training
The purpose of this standard is to provide the delegate with the theoretical and practical knowledge to locate buried utilities safely and effectively for the purpose of avoidance, preventing utility damage and increasing safety during excavation for the construction industry by utilising ground penetrating radar (GPR).
Thermography introduction
The purpose of training delivered against this standard is to provide candidates with knowledge and skills to apply thermography as a diagnostic aid to determine the performance of a building.
Timber treatment building repairs
The purpose of this standard is to provide the delegate with the knowledge and skills to support the following:
interpreting information, deploying signage and barriers, preparing, identifying services, repairing and renewing floor-boards, repairing and renewing decayed joist end(s) and wall plate(s), removing existing timber floor(s), laying suspended timber floor(s), repairing timber stud partition(s), replacing decayed timber lintels and trimmers, installing sub floor air vent(s), safe disposal of waste.
Tolerances and standards for bricklaying occupations
The purpose of this standard is to provide the delegate with the knowledge to support the following: examining poor and good practice; Building Regulations and industry standards; tolerances in wall construction; understanding the guidance and tolerances; identifying where to source the guidance documents.