Search results

The purpose of this standard is to provide the candidate with practical knowledge and skills required as an introduction to setting out of basic metal stud partitions and wall linings, including reading off plans and verbal communication.

---

The purpose of training delivered against this standard is to provide candidates with knowledge covering the installation requirements for timber fire door assemblies and door sets.

---

The purpose of this standard is to provide the candidate with the knowledge and skills to select and install large format internal tiles.

---

The purpose of this standard is to provide delegates with the knowledge and skills to install batten roll roofing.

---

The purpose of this standard is to provide the delegate with the knowledge to support the following: • understanding of the Code Of Practice Design Recommendations. • correct use of welding equipment. • how to fabricate substrate of Dormer with underlay and wood rolls. • understand the ventilation pathways and details. • correct use of tools to fabricate & install gutter front apron with dormer cheeks and upstand flashings. • how to fabricate & install dormer cheeks with front jamb, revel and head coverings. • understand types of dormer roof and associated drainage. • how to Install dormer cover using central wood roll, rear upstand to tiled/slated roof with fixed welted edge down stand. • correct way to recycle waste materials

---

The purpose of this standard is to provide the delegate with the knowledge to support the following: understanding of the Code Of Practice Design Recommendations, correct use of welding equipment. how to fabricate & install flashing components using welding and bossing techniques. how to fabricate & install a chimney penetration through a slated/tiled pitched roof. understanding the suitability of flashing fixing methods in masonry. correct way to recycle waste materials.

---

The purpose of this standard is to provide the delegate with the knowledge to support the following: understanding of the Code Of Practice Design Recommendations, correct use of welding equipment, correct use of tools to install and fabricate roofing details, how to fabricate & install flat roofing with bossed & welded roll ends and abutments with rolls staggered. how to fabricate & install 3 -10 degree sloping roofing with bossed & welded roll ends and abutments with rolls in line. how to fabricate & install pitched roof above 10 degrees with wood rolled, hollow roll & welted joint including fixings. how to fabricate & install parapet gutter with step details. how to fabricate & install box gutter sump with circular spigot outlet, how to fabricate & install box gutter chute to hopper through wall. correct way to recycle waste materials

---

The purpose of this standard is to provide the delegate with the knowledge to support the following: understanding of the Code Of Practice Design Recommendations. correct use of welding equipment. correct use of tools to install weathering components. how to install welted parapet and cornice capping’s with wood roll and pipe penetration. how to correctly fabricate & install tiled/slated valley, ridge and hip weathering’s including fixing and clipping roll ends. correct way to recycle waste materials.

---

This standard covers the principles of levelling and setting out by tape which can be applied to all aspects of construction including earthworks, roads, buildings, foundations, piles, structural steel, structures, reinforced concrete, and houses.

---

This is one of the standards held by the Energy & Utility Skills Register

---