Search results

This standard is exclusively for use by Approved Training Organisations (ATOs). The purpose and scope of this standard is to provide the learner with the skills and knowledge to support the operation of Telescopic handler: all sizes excluding 360 slew (experienced)

---

This standard is exclusively for use by Approved Training Organisations (ATOs). The purpose and scope of this standard is to provide the delegate with the skills and knowledge to support the operation of Telescopic handler: all sizes excluding 360 slew (novice) .

---

Full details of this standard will be published shortly.

---

Full details of this standard will be published shortly

---

The purpose of this standard is to cover information relating to all aspects of operation of temporary suspended access equipment especially with regards to safety, technical processes and emergency procedures.

---

The purpose of this standard is to provide the candidate with the knowledge to install thermal insulation.

---

The purpose of this standard is to provide the candidate with the knowledge and skills to select and install tiling in wet rooms such as: bathrooms, kitchens, toilets, laundries, steam rooms, and swimming pool areas.

---

The purpose of this standard is to provide the candidate with the knowledge and skills to install pump-applied self-smoothing screeds based on a binder of calcium sulphate, in a weather-tight building envelope.

---

The purpose of this standard is to provide the delegate with the knowledge and skills to support the following: interpreting information, deploying signage and barriers, preparing, identifying services, repairing and renewing floor-boards, repairing and renewing decayed joist end(s) and wall plate(s), removing existing timber floor(s), laying suspended timber floor(s), repairing timber stud partition(s), replacing decayed timber lintels and trimmers, installing sub floor air vent(s), safe disposal of waste.

---

The purpose of this standard is to provide the delegate with the knowledge to support the following: examining poor and good practice; Building Regulations and industry standards; tolerances in wall construction; understanding the guidance and tolerances; identifying where to source the guidance documents.

---