Search results

The purpose of training against this standard is to provide the candidates with the knowledge and understanding of carrying out floor sawing operations safely.

---

The purpose of this standard is to provide the delegate with the knowledge and understanding to interpret relevant information required to unload, store and prepare gas membrane installation.

---

The purpose of training against this standard is to provide the candidates with the knowledge and understanding of carrying out hand held diamond drilling operations safely

---

This standard is exclusively for use by Approved Training Organisations (ATOs). The purpose of this standard is to enable the delegate to develop knowledge and understanding of handling difficult situations regarding performance, discipline, conflict, stress and diversity as required by a practising or potential site supervisor.

---

The purpose of this standard is to give candidates an understanding of policies and procedures relating to the safe hire of cartridge and IC fixing tools.

---

The purpose of this standard is to give the candidate an understanding of the Abrasive Wheels regulations and the hire of this equipment under the Provision and Use of Work Equipment Regulations (PUWER).

---

The purpose of this standard is to give the candidate an understanding of the procedures that must be used in the safe hire of ladders and low level staging within the Provision and Use of Work Equipment Regulations (PUWER), Work at Height Regulations (WAH) and to industry lead body requirements for compliance at all levels.

---

The purpose of this standard is to provide the delegate with the knowledge to fully understand the prestart requirements of moling and trenchless technologies including an understanding of potential hazards and the avoidance of risk from other underground services.

---

The purpose of this standard is to provide the delegate with the knowledge and skills to support the following scope: introduction to spray painting, health & safety in spray painting, understanding paint materials, understanding airless spray, understanding conventional spray, understanding plural spray

---

The purpose of this standard is to provide the delegate with the knowledge to support the following: the role of compartment walls and floors; understanding how linear joint seals and cavity barriers (full fill and open state) work and their place in the wider passive fire protection system; legislation and guidance associated with firestopping linear joint seals and cavity barriers in compartment walls and floors; considerations to make before selecting a fit for purpose firestop seal, in terms of fire resistance and other salient properties such as durability, acoustic, air tightness and structural movement requirements; considerations when installing generic types of linear joint seals and cavity barriers (full fill and open state); considerations on completion of the installation of firestop seals.

---