Search results

---

The purpose of training delivered against this standard is to provide delegates with an introduction to the installation of strip and plank wooden floors using approved methods in commercial and domestic environments.

---

The purpose of training delivered against this standard is to provide candidates with knowledge of the updated BS 8102:2009 code of practice for protection of below ground structures against water from the ground.

---

The purpose of Supervision of concrete pumping operations - refresher standard is for delegates who have previously passed training to the full Supervision of concrete pumping operations standard or subsequent refresher training and can provide proof of attendance.

---

The purpose of training delivered against this standard is to provide candidates with the knowledge to identify, resolve and report problems relating to dampness and/or timber infestation/decay in buildings.

---

The purpose of training delivered against this standard is to provide candidates with knowledge to install new basements and convert existing basements, including: design, planning, and installation of structural waterproofing projects below ground.

---

This standard covers the training requirements for an operative to be able to safely and correctly inspect system scaffolds in accordance to manufacturers' instructions. This training standard was previously held under the occupational area Scaffolding.

---

This standard covers the skills and knowledge for the safe use of the system scaffold product, in accordance with the manufacturer’s instructions. This training standard was previously held under the occupational area Scaffolding.

---

The purpose of this standard is to prepare candidates who have responsibility for manoeuvring vehicles on, off and within busy construction sites or premises to recognise the importance of accepting and dispersing vehicles in a safe and efficient manner, recognise significant risks and give clear and precise signals to vehicles.

---

This standard is exclusively for use by Approved Training Organisations (ATOs). The purpose and scope of this standard is to provide the learner with the skills and knowledge to support the operation of Telescopic handler: all sizes excluding 360 slew (experienced)

---