Search results

The purpose of training delivered against this standard is to provide site managers with the ability to implement all health, safety, welfare, and environmental legislation. To understand new guidance and industry best practice and state their duties and responsibilities with regards to health, safety and welfare within the built environment.

---

The purpose of this standard is to give candidates an understanding of policies and procedures relating to the safe hire of cartridge and IC fixing tools.

---

The purpose of this standard is to give the candidate an understanding of the Abrasive Wheels regulations and the hire of this equipment under the Provision and Use of Work Equipment Regulations (PUWER).

---

The purpose of this standard is to give the candidate an understanding of the procedures that must be used in the safe hire of ladders and low level staging within the Provision and Use of Work Equipment Regulations (PUWER), Work at Height Regulations (WAH) and to industry lead body requirements for compliance at all levels.

---

This standard focuses on the use and application of the underpinning historical, technological and theoretical knowledge and the requisite practical skills to undertake the correct evaluation and selection of materials, tools, equipment and craft practices relevant to the history of clay tile and slate roofing.

---

The purpose of this standard is to provide the delegate with the knowledge to fully understand the prestart requirements of moling and trenchless technologies including an understanding of potential hazards and the avoidance of risk from other underground services.

---

The purpose of this standard is to provide the delegate with the knowledge and skills to support the following scope: introduction to spray painting, health & safety in spray painting, understanding paint materials, understanding airless spray, understanding conventional spray, understanding plural spray

---

The purpose of training delivered against this standard is to provide candidates with the practical skills and knowledge to be able to safely and effectively understand the design and installation requirements of drains sumps and pumping ancillaries of the Type C Cavity Drain Membrane System. It is aimed at people working in the Waterproofing sector.

---

The purpose of this standard is to provide the delegate with the knowledge to support the following: the role of compartment walls and floors; understanding how linear joint seals and cavity barriers (full fill and open state) work and their place in the wider passive fire protection system; legislation and guidance associated with firestopping linear joint seals and cavity barriers in compartment walls and floors; considerations to make before selecting a fit for purpose firestop seal, in terms of fire resistance and other salient properties such as durability, acoustic, air tightness and structural movement requirements; considerations when installing generic types of linear joint seals and cavity barriers (full fill and open state); considerations on completion of the installation of firestop seals.

---

The purpose of this standard is to provide the delegate with the knowledge to support the following: the role of compartment walls and floors; understanding how service penetration seals work and their place in the wider passive fire protection system; legislation and guidance associated with firestopping service penetration sealing in compartment walls and floors; considerations to make before selecting a fit for purpose firestop seal system including other salient properties such as durability, acoustic, air tightness and structural movement requirements; considerations when installing generic types of firestop seal systems; considerations on completion of the installation of firestop seal systems.

---